This package is a brushless system and lighting control system designed for the FCX18 LC80 vehicle. The lighting control system is recommended to be used in conjunction with a MG44 V6 Transmitter. When paired with the V6 transmitter, all lighting wires will work. However, when paired with the V5 transmitter, the headlights and spotlights will lose their lighting effects, while signal lights and rear lights (if present) will still function normally.

Package Includes:
Combo A (w/o MG44 V6 Transmitter)
1×BATRAZZI 3200KV Outrunner Motor, Receiver and FOC ESC
1×FCX18 LC80 Aluminum Receiver Mount
1×FCX18 LC80 Light Control System Set
1×Transmission Middle Cover
2×JST-Dupont Converter Cables

Combo B (w/ MG44 V6 Transmitter)
1×BATRAZZI 3200KV Outrunner Motor, Receiver and FOC ESC
1×FCX18 LC80 Aluminum Receiver Mount
1×FCX18 LC80 Light Control System Set
1×Transmission Middle Cover
2×JST-Dupont Converter Cables
1×BATRAZZI MG44 V6 Transmitter

Light System Installation:

- Connect the light wires to the light control system, and then use a Dupont-to-Dupont Connection Cable to connect to the receiver’s CH4 port (as shown in the diagram)
- Use the included Y-line if you want the headlights and spotlights to work simultaneously. Simply plug the combined connection into the Head 4 port of the light control system.
- Double-check to match the correct polarity (positive and negative) during setup.

2.Operation:
- Transmitter CH4 Button Controls:
①Press once: Turn on the headlights.
②Press twice: Activate the spotlights.
③Press three times: Turn off all lights.

- For simultaneous operation of headlights and spotlights, follow the Y-line connection instructions above.

Note: For the installation of the light control system on the FCX18 LC80, you can choose the installation location yourself. The above illustration is for reference only.

Specifically Built for the FMS FCX18 LC80.
This light set is custom-assembled for the FCX18 LC80, and it’s may not perform as intended when used with other RC vehicles.