Are the fog light cutouts pre-drilled and ready to use?

The fog holes are molded into the panel during manufacturing. Before installation, verify your vehicle's OEM bumper hole locations and sensor mounting points align with the cutouts. You may need to drill or modify the cutout slightly depending on your specific setup — use the OEM holes as your reference guide.

Will this fit with my factory bumper reinforcement bar?

This is a cover panel designed to mount over your existing bumper structure. Confirm that your vehicle's reinforcement bar height and mounting points are compatible with the lower valance profile before purchasing. If your OEM bar protrudes beyond standard spec, fitment may require modification to the cover or bar.

What surface prep should I do before painting?

Sand the surface with appropriate grit to remove any gloss, wipe clean, and apply your chosen primer and paint system. The FRP surface is prepared to accept paint directly — follow your paint manufacturer's instructions for prep and application.