Will this bumper clear my factory fog lights and sensor cutouts?

This cover is designed to work with factory mounting geometry. Before final fitment, verify your vehicle's OEM fog hole locations and any parking sensor openings on the lower valance — you may need to drill or route small apertures to match your setup. The single-piece design gives you flexibility to mark and cut precisely once mounted.

What prep is needed before painting?

Sand the surface with fine-grit sandpaper and wipe clean to remove any dust. Apply your chosen primer and paint system following the product manufacturer's instructions. FRP responds well to standard automotive primers and urethane topcoats.

Does the lower valance fit under the bumper reinforcement bar?

The 1M design sits slightly lower than stock, so test-fit the lower valance clearance against your existing impact bar and core support before final fastening. Minor shims or adjustment to the mounting points may be needed depending on prior body work or alignment. Confirm fitment at each factory mount location during dry-fit.